- product information
A lacquer with all the features of Bona Traffic HD but formulated to meet the highest standards for slip resistance in workplaces and other situations where an increased risk of spills exists.
Bona Traffic HD Anti Slip is an ideal choice for stairs, nurseries, kitchens and similar locations.
Can be used to protect untreated wood as well as prefinished floors.
- technical specifications
Brand Bona No of coats 2-3 Coverage Up to 8m² per litre Drying Times 2h 30m Size 5lt MPN 7312799215538 GTIN WT155846001
• Increases protection from accidental slips
• Ultimate speed and durability
• Allows full traffic after 12 hours Easy and safe to apply
• Very low odour
• GreenGuard Gold certified for very low indoor emissions.
• Recommended for schools and nurseries.
• EC1RPlus classified for very low emissions (the industry’s most stringent standard on indoor emissions).
• Very low solvent content (VOC), <5%.
Before Using Bona Traffic HD Anti Slip
Prior to application the surface must be pre-treated with a waterborne primer from Bona. Ensure floor is acclimatized to its end-use environment, well sanded, dry and free from sanding dust, oil, wax and other contamination.
Allow lacquer and hardener to reach room temperature, insert filter and shake the container thoroughly before use.
Optimal application conditions are between 18-25C and 30-60% relative air humidity. High temperatures and low humidity shorten, low temperatures and high humidity lengthen drying time. Minimum temperature for use is 13C. Preparation of previously lacquered floors
Bona Traffic HD Anti-slip has in general very good adhesion to factory pre-finished and previously lacquered floors but the surface must be carefully cleaned and abraded prior to overcoating. See separate guideline for overcoating recommendations.
How To Apply Bona Traffic HD Anti Slip
Shake the Traffic HD can and add one bottle of Traffic HD Hardener.
Immediately shake the mixture thoroughly for 1 minute and then insert the enclosed filter.
If mixing smaller quantities of lacquer then pour the required amount of lacquer into a separate can. 1 litre of lacquer corresponds to one part of hardener. 2 litres to two parts a.s.o.
The mixture of lacquer/hardener should be used directly or at least within 4 hours.
2. Apply the lacquer using a Bona Roller.
Roll with a smooth, flowing motion alternately across and with the grain of the wood avoiding accumulations of product.
Always maintain a “wet edge” to avoid overlaps.
Allow to dry properly before applying further layers.
Anticipate slightly longer drying time for each layer that is applied.
If necessary make an intermediate sanding using a screen or the Bona Scrad System grit P150 (or finer) and remove dust before applying a final layer of lacquer.
Note: If the previous layer of lacquer has been allowed more than 24 hours drying time then an intermediate sanding is always required.
Floor will take light foot traffic approximately 8 hours after the final application and may be put into full use after 12 hours.
Allow the surface to dry for at least 3 days before covering with carpets or other floor coverings.
Also avoid placing heavy objects and avoid damp mopping the floor during this time.
Note: If Traffic HD Anti-slip has been combined with Bona Prime Deep and Bona Create then the surface must be allowed to cure for 1 week before covering the surface
Maintenance & Cleaning
Clean the floor with Bona Cleaner or Bona Wood Floor Cleaner and a microfibre pad.
For public areas it may be necessary to introduce a machine based cleaning programme.
Worn surfaces can be renewed by applying a new coat of Bona Traffic HD Anti-slip. Note: Bona Freshen Up and Wood Floor Refresher cannot be used with Bona Traffic HD Anti-slip as the slip resistance qualities will be affected.
Similarly the floor should not be maintained with a polish or other floor maintenance products.
- Additional Information