how to apply dulux diamond glaze
Brush or short pile mohair roller only.
Do not spray.
Do not use below 10ºC or in areas of high humidity or condensation.
Practical Coverage Application will depend on the type and condition of the surface.
Typical figures which can be achieved are: Bare wood: 12-20m² per litre. Previously coated wood: 20-25m² per litre.
STIR THOROUGHLY BEFORE USE.
Seal all new or bare wood by applying one coat of Clear Gloss Diamond Glaze from Dulux Trade.
Apply 2 or 3 coats of Diamond Glaze from Dulux Trade.
Apply evenly and consistently, taking care to keep the 'wet edge' alive and finish off along the grain.
Apply a small test area first to check adhesion and appearance.
When recoating allow at least 2 hours between coats.
Rub down lightly along the grain between coats using a fine grade adhesive paper.
Light foot traffic is allowed after 24 hours but to prevent possible damage to floor while the full mechanical resistance develops, avoid heavy wear and do not replace carpet or rugs or move furniture for at least 7 days after application.