- product information
A very fast drying zinc rich primer based on a styrene-acrylic resin.
The product contains pure zinc as pigment and provides excellent protection against corrosion.
The super-fast Zinc Primer should be used on new, bare steel or galvanised steel surfaces.
Galva Expresse 2180 is intended to be applied on small areas or for touch-up.
Can be recoated with non-saponifiable coatings.
The product should be used as a primer or as a single coat in light industrial exposures, corrosive environments and high humidity areas.
- technical specifications
Size 500ml For use on
New, bare steel, blasted steel or galvanized steel surfaces Appearance Matt Drying times 20°C/50% r.v. To touch
5 Minutes Drying times 20°C/50% r.v. To Recoat Within 1 hour or after 48 hours Binder n/a Heat Resistance Up to 350 °C Dry Heat Theoretical Coverage
1.4 m² per spay can at 35 μm dry MPN 2180 GTIN
- • Matt grey appearance
- • To handle after just 10 minutes (at 20°C)
- • For new, bare, rust free metal or galvanised steel
- • Resists 400 hours of salt spray testing (DIN)
- • Heat-resistant up to 350 °C
- • Ideal for production and construction work
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means.
Prime or spot prime with the recommended RUST-OLEUM Primers. Sand intact coatings to provide a proper key for adhesion.
The surface must be clean and dry during application.
DIRECTION FOR USE
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard.
Shake frequently during use. Hold can at least 25 cm from surface.
Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags.
Apply a single, thin layer and avoid application of thick layers. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
For good results the relative humidity shall be below 85% and the temperature of the can and substrate above 0°C.
- Additional Information