- product information
Rust-Oleum Transparent Topcoat 2500 should be applied over Rust-Oleum Hard Hat Fluorescent Topcoats 2200 or Metallic Topcoats 2100 or can be used to restore the gloss of faded old coatings.
Can be applied direct on several metals like: aluminium, brass, bronze, chrome and copper. Intended for small maintenance jobs or for touch-up.
Should be used in light industrial exposures, normal humidity and interior applications.
- technical specifications
Size 500ml For use on
New, bare steel, blasted steel or galvanized steel surfaces Appearance Gloss Drying times 20°C/50% r.v. To touch
15 Minutes Drying times 20°C/50% r.v. To Recoat After 1 Hour Binder n/a Heat Resistance 100°C (dry heat) Theoretical Coverage
3.5 m² per spray can at 15 μm dry
MPN 2500 GTIN 8715743006197 EXTRA 2X TINS YOUR CUSTMER USED REGARDS IAN
- • Protection of copper, chrome, silver, bronze, nickel, aluminium
- • Extra durability to metallic/fluorescent coatings
- • Non-yellowing (UV-resistant)
- • To handle after 30 minutes (at 20°C)
- • Heat-resistant up to 100 °C
Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means.
Prime or spot prime with the recommended RUST-OLEUM Primers. Sand intact coatings to provide a proper key for adhesion.
The surface must be clean and dry during application.
DIRECTION FOR USE
Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard.
Shake frequently during use. Hold can at least 25 cm from surface.
Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags.
Apply a single, thin layer and avoid application of thick layers. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
For good results the relative humidity shall be below 85% and the temperature of the can and substrate above 0°C.
- Additional Information