How To Apply Sadolin PV67
Sadolin PV67 Heavy Duty Varnish should be applied in full flowing coats ensuring all surfaces are fully coated.
For best results use a soft bristle brush, lambs wool applicator or quality woven short to medium pile roller.
Clean application tools must be used ensuring any fibre shed is removed prior to use by thorough washing (then allow to fully dry) or by using masking tape.
Following surface preparation in accordance with the manufacturers recommendations, finish with 3 full coats of Sadolin PV67 Heavy Duty Varnish allowing a minimum of 3-4 hours drying between coats.
Avoid over brushing as this will cause brush marks and result in a poor quality finish and also reduce the level of protection afforded.
Carefully denib the fist coat using a fine grade nylon abrasive pad or a fine grade (P240 or finer) wet or dry silicone carbide abrasive paper in the direction of the grain before overcoating.
Do not break through the surface coating.
Remove all dust.
All subsequent coatings should be applied as soon as possible after the previous coat has fully cured.
If recoating after more than 48 hours it is essential to lightly abrade the surface to remove surface gloss and leave overnight for the surface to condition prior to over lacquering
For further technical information on Sadolin PV67 please refer to relevant product datasheet and comprehensive pack instructions.