- product information
Treatex Bangkirai Oil is an exterior wood finish which provides long term protection from UV rays and weather damage.
It is manufactured on a base of natural sustainable raw materials including sunflower oil, soybean oil and rapeseed oil.
- technical specifications
Brand Treatex Pack Size 2.5lt Coverage Approximately 50m² in one coat depending on the timber and method of application. Useage Interior & Exterior Recommended Timbers Bangkirai, Yellow & Red Balau, Karri, Massaranduba, Iroko & Ipe Application Decking and garden furniture MPN 31280H GTIN
- • Easy to apply
- • UV resistant
- • Highly water resistant
- • Contains no biocides or preservatives
- • Safe for use on children's toys
- • Not suitable for high tannin content timbers e.g. oak
- • Will not flake or peel
- • Very hard wearing
before applying treatex bangkirai oil
Whilst Treatex Bangkirai Oil can be applied over most previous finishes it works much better on unfinished timber.
When overcoating a previously finished surface, a trial application is essential.
If a previous finish is to be overcoated then it should be lightly sanded.
Flaking or peeling finishes must be fully removed prior to application.
Ensure the timber is dry and free from possible contaminates e.g. algae, grease, dirt, dust, etc.
We advise that when using Treatex Bangkirai Oil, sufficient product is purchased to complete the whole project and when more than one tin is required it is advisable to mix them together before use.
Timber must have a moisture content below 18%.
Temperature must be greater than 8º
how to apply treatex bangkirai oil
Stir tins thoroughly, before and during use.
Use a brush or roller to evenly apply Treatex Bangkirai Oil allowing approximately 50ml per m².
Pay particular attention to end grain, on end grain apply wet on wet until product is no longer absorbed by the timber.
After approximately 12 hours the first coat can be overcoated.
Apply with a brush or roller a second coat of Treatex Bangkirai Oil, again allowing roughly 50ml per m².
After the second coat leave for approximately 12 hours to dry.
- Additional Information
DetailsTreatex Bangkirai Oil Safety Sheet Size: (215.99 KB)